Project Toyota crusher (new comanche)

Just picked up a 1989 comanche long bed 4.6 stroker ba10 pos 4x4. current specs are

-4.6 strocker

-ba-10/np231

-5.5 rubicon express lift

-33/12.50/15 cooper muds

-tussed dana 30 yukon axle shafts alloy usa joints and ox locker 4.56s

-29 spline 8.25 rear open 4.56s

next to do list is rear locker and long arms and mount my ox locker lever just sitting next to the seat righ now. i have to swap trannys to the one in it has a small crack where the t case meets up but i have a spear tranny to go in it and the the very next thing to do. Oh and the comanche on the left is my other one its a 1989 4 banger 2 wheel drive all stock and flawless

Proud owner of two comanches now :cheers:

lookin good man :thumbsup:

nice :yes: i have the exact same shifter nob :yes: looks allitle weird on an automatic though lol :rotf:

How did u get that to work with out a push button to release it? And thanks for the comments

mean lookin machine !! -----looks great.

Thanks man

Cool set up dude , did you buy it from someone on NAXJA ?

Just picked up a 1989 comanche long bed 4.6 stroker ba10 pos 4x4.

 

 

Proud owner of two comanches now :cheers:

nice :yes: i have the exact same shifter nob :yes: looks allitle weird on an automatic though lol :rotf:

:huh???:

How did u get that to work with out a push button to release it?

:nuts:

A ba10 trans is a stick shift... :fool: You can tell by the shifter and boot. There is also a clutch pedal in the picture. :rotf:

:cheers:

Nice MJ, enjoy the build up. :thumbsup:

Lol I was confused about that and yes I bought it off a naxja guy

Nice looking trucks! :cheers:

I hope the replacement tranny is not a BA 10/5, seems pointless to put that behind a 4.6 stroker.

Unfortuntly it is. Ba10 for now till I get the ax15 parts going for now I just need to be able to drive it